AudioControl the Epicenter Micro Bass Restoration Processor & Line-Out Converter

Description: Brand New AudioControl The Epicenter Micro Bass restoration processor and line output converter Add bass to your aftermarket system's high-level source Most factory radios dial down deep, low-hitting bass notes to protect flimsy factory speakers. The Epicenter Micro from AudioControl takes amplified speaker-level signals, converts them into the high-quality preamp signals your sub amp needs, and then adds the bass that's missing. Even when listening to traditionally bass-weak classical, jazz, folk, or Tejano music, you'll finally be able to hear all the good bass you've been missing.How does it do it? Sophisticated processing analyzes the incoming signal and synthesizes low-bass fundamental tones, increasing bass response tremendously. A single band ParaBASS® equalizer lets you fine-tune your subwoofer's tone. A selectable subsonic filter removes extreme low frequencies so your amps and subs will play more efficiently. The Epicenter Micro will also connect to any receiver with preamp outputs — its balanced inputs will reject noise from your car's electrical system for ultra-clean output.Installation conveniences The included ACR-4 dash-mount wired remote control allows you to adjust the level of your sub channel on the go. Load selection switches make OEM factory system integration easier, so The Epicenter Micro will work with almost any vehicle's sound system. Selectable turn-on modes include GTO™ Signal Sense (DC offset), audio sigal , or remote 12-volt input. Product highlights:active 2-channel line driver/output converter with bass restorationdesigned to work with aftermarket and factory systemsprovides up to 9.5 Vrms output (selectable level: 5, 7, 10V)preamp and speaker-level inputsspeaker-level inputs handle up to 40V (400 watts RMS)speaker-level inputs feature switchable load resistance (20, 60, or 20,000 ohms) to prevent factory stereo shut-downEpicenter bass restoration increases bass responsePara-Bass controls adjust center-frequency and width of bass EQ processingMore info:ACR-4 wired remote includedswitchable Programmable Frequency Match (PFM) subsonic filter (20 Hz, 12/dB octave)selectable ground isolation helps eliminate noiseauto turn-on via 12V remote, DC offset, or audio signal detect12-volt turn-on lead outputwiring, fuse, and hardware not included with device18-gauge power and ground leads and a 1-amp fuse recommendeddimensions: 5-1/8" W x 1" H x 3" DWhat's in the box:Bass Restoration ProcessorTwo 4-pin Phoenix connectors (installed)ACR-4 wired remote control (dash mount)17' RJ-14 Remote cable1.5mm Hex keyQuick start guideQC checklistBrand New2 Year CarStereoWarehouse Warranty

Price: 179 USD

Location: Los Angeles, California

End Time: 2024-10-28T20:49:19.000Z

Shipping Cost: 0 USD